![]() ![]() This assured even signal transmission levels as the level did not deviate in amplitude.įirst, I need to talk about an important unit, the dBm. A transmitter was placed onstage with a sine wave being played into it. Then from there I used a length of LMR 200 coax to connect into the different devices in test. There was a SMA to BNC adaptor placed on the unit. This analyzer has a 50 ohm SMA antenna port on it, so to connect the antennas up to it, I needed some adaptors. ![]() I conducted a series of tests using the RFExplorer handheld RF spectrun analyzer. So we can treat the wireless microphone receivers the same as TV’s. ![]() Wireless microphone receivers do not transmit either, they only receive. Being that TV’s don’t transmit themselves, only receive signal, you can hook as many TV’s up as you want without causing harm to a television. The coaxial splitter uses transformers or different combinations of resistors to split a signal to its separate outputs. Then the outputs would go off to your different TV’s allowing multiple TV’s to get the same signal. This is something that you would connect your TV antenna to on one side. Thus we find ourselves looking at a two-way coaxial splitter. I figured in my mind that because TV and the wireless microphones share the same frequency spectrum, some of the tv splitters might work the same with wireless microphones as they do with TV. This is me at the top of my ham radio tower that I purchased. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |